乔燕, 孙传智, 李爱群, et al. Experimental Study on Mechanical Properties of High Strength Steel Bar HRB600 under High Strain Rate[J]. 2019, 39(6): 905-911. DOI: 10.13409/j.cnki.jdpme.2019.06.004.
Experimental Study on Mechanical Properties of High Strength Steel Bar HRB600 under High Strain Rate
The dynamic plastic constitutive model of steel rebar should be used in seismic analysis of reinforced concrete structures.As a new generation steel rebar
there is no published research on the mechanical properties of HRB600 under high strain rate.In this paper
the tensile mechanical properties of HRB600 under different strain rates were studied
and the mechanical properties of HRB600 under different strain rates were obtained.The yield strength increased by11.5%and the ultimate strength increased by 8.9%.The expression of improvement coefficient of HRB600 under high strain rate was proposed.The results show that the yield strength and ultimate strength of reinforcement improve with the increase of strain rate.Under the condition of the same strain rate
the improvement coefficient of yield strength is greater than that of ultimate strength.Compared with low strength steel
the sensitivity of strain rate of HRB600 is significantly lower than that of HPB235
HRB335 and HRB400.But there is little difference between HRB600 and HRB 500.The ultimate strain rate sensitivity of HRB600 is significantly higher than that of the low strength steel bars.On the basis of the experimental data
a dynamic plastic constitutive model of HRB600 under high strain rate is obtained.The research results can be used as the basis for seismic evaluation of HRB600 high strength reinforced concrete structure.
Effects of Strain Rate on Reinforced Concrete Structure under Seismic Loading [J] . Min Li,Hongnan Li. Advances in Structural Engineering . 2012 (3)
Study on Strain Rate Effect in High-Rise Reinforced Concrete Shear Wall Structure [J] . Zhang Hao,Li Hong Nan,Wang Zhe. Advanced Materials Research . 2011 (243)
Bridge Model Updating Using Response Surface Method and Genetic Algorithm [J] . Lu Deng,C. S. Cai. Journal of Bridge Engineering . 2010 (5)
Flow stress optimization for 304 stainless steel under cold and warm compression by artificial neural network and genetic algorithm [J] . S.H. Mousavi Anijdan,H.R. Madaah-Hosseini,A. Bahrami. Materials and Design . 2005 (2)
Rate‐of‐Loading Effects on Pseudodynamic Tests [J] . Pui&hyphen,Shumi B. Shing,Stephen A. Mahin. Journal of Structural Engineering . 1988 (11)