西安建筑科技大学土木工程学院,陕西 西安 710055
王威(1972—),男,教授,博士。主要研究方向为钢与混凝土组合结构。E-mail:wangwgh1972@163.com
纸质出版:2021-10-15
移动端阅览
王威,向照兴,王俊等.波形钢板剪力墙几何初始缺陷的敏感度分析∗[J].防灾减灾工程学报,2021,41(05):1037-1044.
WANG Wei,XIANG Zhaoxing,WANG Jun,et al.Sensitivity Analysis of Geometric Initial Defects of Corrugated Steel Plate Shear Wall[J].Journal of Disaster Prevention and Mitigation Engineering,2021,41(05):1037-1044.
王威,向照兴,王俊等.波形钢板剪力墙几何初始缺陷的敏感度分析∗[J].防灾减灾工程学报,2021,41(05):1037-1044. DOI: 10.13409/j.cnki.jdpme.201904069.
WANG Wei,XIANG Zhaoxing,WANG Jun,et al.Sensitivity Analysis of Geometric Initial Defects of Corrugated Steel Plate Shear Wall[J].Journal of Disaster Prevention and Mitigation Engineering,2021,41(05):1037-1044. DOI: 10.13409/j.cnki.jdpme.201904069.
为研究波形钢板剪力墙的力学性能,进行了竖向和水平波形钢板剪力墙的试验研究,试验结果表明:水平波形钢板剪力墙的承载能力和滞回性能均优于竖向波形钢板剪力墙。试件均为纯钢构件,在制作、运输及安装过程中,易产生局部的几何变形,后续通过ABAQUS有限元分析软件建立10个有限元模型,考察不同初始缺陷大小对波形钢板剪力墙力学性能的影响,并与试验结果进行对比。通过对比结果分析得出以下结论:初始缺陷是波形钢板剪力墙建模分析时不可忽略的因素;随着初始缺陷峰值的增大,竖向和水平波形钢板剪力墙的承载力下降速率均随之增大,当初始缺陷峰值为腹板高度的1/250时,与完善剪力墙模型相比,其承载力分别下降了19%和9.5%;添加同样幅度的初始缺陷,其对竖向波形钢板剪力墙的力学性能影响远大于对水平波形钢板剪力墙力学性能的影响。
In order to study the mechanical properties of corrugated steel plate shear wall, the experimental study of vertical and horizontal corrugated steel plate shear walls was carried out. The results show that the bearing capacity and hysteretic behavior of horizontal corrugated steel plate shear walls were better than that of vertical walls. The test pieces are all pure steel members, and local geometric deformation is easy to occur during the production, transportation and installation process. Then ten finite element models were established by ABAQUS finite element analysis software to investigate the effects of different initial defects on the mechanical properties of corrugated steel plate shear walls and compared with the experimental results. Through the analysis of the comparison results, the following conclusions are drawn: the initial defect is a factor that cannot be ignored in modeling and analysis of corrugated steel plate shear wall; With the increase of the peak value of the initial defect, the decrease rate of the bearing capacity of the vertical and horizontal wave steel plate shear walls increases. When the initial defect peak value is 1/250 of the web height, the bearing capacity of the shear wall model decreases by 19% and 9.5%, respectively, compared with the perfect shear wall model; The effect on the mechanical properties of vertical corrugated steel plate shear wall is much greater than that of horizontal corrugated steel plate shear wall by adding initial defects of the same amplitude.
Wang W , Wang Y , Lu Z . Experimental study on seismic behavior of steel plate reinforced concrete composite shear wall [J]. Engineering Structures , 2018 , 160 ( 4 ): 281 - 292 .
王威 , 张龙旭 , 苏三庆 , 等 . 波形钢板-混凝土组合剪力墙抗震性能试验研究 [J]. 建筑结构学报 , 2018 , 39 ( 10 ): 75 - 84 .
Wang W , Zhang L X , Su S Q , et al . Experimental research on seismic behavior of corrugated steel plateshear wall [J]. Journal of Building Structures , 2018 , 39 ( 10 ): 75 - 84 . (in Chinese)
王萌 , 杨维国 , 钱凤霞 . 钢板剪力墙水平荷载作用下简化滞回理论模型研究 [J]. 建筑结构学报 , 2017 , 38 ( 10 ): 59 - 67 .
Wang M , Yang W G , Qian F X . Simplified hysteretic theoretical model of steel plate shear wall structure under horizontal load [J]. Journal of Building Structures , 2017 , 38 ( 10 ): 59 - 67 . (in Chinese)
孙军浩 . 波纹钢板剪力墙的抗侧及抗震性能研究 [D]. 天津 : 天津大学 , 2016 .
Sun J H . Research on lateral performance and seismic behavior of corrugated steel plate shear walls [D]. Tianjin : Tianjin University , 2016 . (in Chinese)
刘佳 , 金双双 , 欧进萍 . 防屈曲开斜槽耗能钢板剪力墙的滞回性能分析 [J]. 防灾减灾工程学报 , 2014 , 34 ( 3 ): 296 - 301 .
Liu J , Jin Sh Sh , Ou J P . Hysteretic behavior of buckling-restraining slotted steel plate shear wall [J]. Journal of Disaster Prevention and Mitigation Engineering , 2014 , 34 ( 3 ): 296 - 301 . (in Chinese)
Emami F , Mofid M . On the hysteretic behavior of trapezoidally corrugated steel shear walls [J]. Structural Design of Tall & Special Buildings , 2014 , 23 ( 2 ): 94 - 104 .
李靓姣 . 波浪形钢板墙的受力性能及设计方法研究 [D]. 北京 : 清华大学 , 2012 .
Li J J . Research on behaviour and design methods of sinusoidal steel plate wall [D]. Beijing : Tsinghua University , 2012 .
赵秋红 , 李楠 , 孙军浩 . 波纹钢板剪力墙结构的抗侧性能分析 [J]. 天津大学学报(自然科学与工程技术版) , 2016 , 49 ( 增1 ): 152 - 160 .
Zhao Q H , Li N , Sun J H . Analysis on lateral performance of sinusoidally corrugated steel plate shear walls [J]. Journal of Tianjin University( (Science and Technology) , 2016 , 49 ( Sup 1 ): 152 - 160 . (in Chinese)
郭彦林 , 童精中 , 姜子钦 . 波形腹板钢结构设计原理与应用 [M]. 北京 : 科学出版社 , 2015 .
Gou Y L , Tong J Zh , Jiang Z Q . Design fundamentals and application of corrugated-web steel structures [M]. Beijing : Science Press , 2015 . (in Chinese)
中国建筑科学研究院 . 建筑抗震试验规程 JGJ/T 101-2015 [M]. 北京 : 中国建筑工业出版社 , 2015 .
China Academy of Building Research . Specification forseismic test of buildings:JGJ/T 101-2015 [M]. Beijing : China Architecture & Building Press , 2015 . (in Chinese)
Oh J Y , Lee D H , Kang S K . Accordion effect of prestressed steel beams with corrugated webs [J]. Thin-Walled Structures , 2012 , 57 ( 1 ): 49 - 61 .
石亦平 , 周玉蓉 . ABAQUS有限元分析实例详解 [M]. 北京 : 北京机械工业出版社 , 2006 .
Shi Y P , Zhou Y R . Detailed Explanation of ABAQUS finite element analysis Example [M]. Beijing : Beijing Machinery Industry Press , 2006 . (in Chinese)
郭彦林 , 张庆林 , 王小安 . 波浪腹板工形构件抗剪承载力设计理论及试验研究 [J]. 土木工程学报 , 2010 , 43 ( 10 ): 45 - 52 .
Guo Y L , Zhang Q L , Wang X A . A theoretical and experimental study of the shear strength of H-Shapedmembers with sinusoidal corrugated webs [J]. China Civil Engineering Journal , 2010 , 43 ( 10 ): 45 - 52 . (in Chinese)
0
浏览量
0
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
苏公网安备32010202012147号
